Using firewood is a more eco-friendly way to heat up. However, you should not cut just any wood for heating. You can mix hardwoods and softwoods to get your fire started well and maintain it better. Woods like oak, beech, pine, fir, and others are to be favored. How can you easily cut such wood? Discover our tips in the following lines.
First, cut down the tree
Before you can successfully cut wood, you must first fell the tree of your choice. For this, you can use a chainsaw that you will find on www.tronconneuse.xyz. Easy to use with all possible safety systems, this tool will help you obtain your firewood more simply. To fell the tree, you need to clear the base of its trunk and all the leaves and branches that might obstruct your view. Then, you can set up ropes around the trunk. This way, the tree will fall in the right direction. Now, you will make a horizontal cut at the lowest point on the side where the tree is supposed to fall.
You may also like : How to Detect Signs of Surface Piercing Rejection
The cut you make here should reach ¾ of the tree’s diameter. After that, you will make an angled cut above the one just made at 45°. This cut should connect with the one you just made. Now, you will make the felling cut still at 45° on the opposite side from where the tree will fall. Do not cut all the way until these two cuts meet. Leave a few centimeters between them. Then, you can insert wedges to allow the tree to fall in the correct direction. Right after that, pull on the ropes and the tree will be on the ground.
Remove the branches from the trunk
Now that the tree is on the ground, you need to branch it. This way, the trunk will be completely bare. Here, you will still use your chainsaw. For this purpose, you will first cut the branches that are on the upper part of the trunk. After that, you will take care of the branches that are on the sides of the trunk. If you find an easier way, also cut the branches that are at the lower part of your trunk. If this is not possible, then wait until you have cut the trunk. How to cut the trunk then?
Recommended read : How to Easily Access Your School Email: The Example of the Montpellier Academy
The trick to easily cut the wood into logs
If you are facing a trunk that is too heavy, you can cut it on the ground. Otherwise, this work can be done by placing the bare trunk on a sawhorse. You will again use your chainsaw. Position the teeth of the device so that they penetrate well into the trunk. To make the cut, you will make a slight forward rotational movement without removing the teeth. This way, you will obtain logs that can truly be used for your heating. To transport your logs to where they will be used, you can use a log clamp, a lifting hook…